Vyteknical Advisor

Vytek manufactures a wide range of CO2 and Fiber cutting and marking systems.

Menu

Skip to content
  • Home

laser

Cutting aluminum, brass or copper? It’s all about peak power enabled by a pulsed laser.

August 22, 2016August 22, 2016Vytek195 4 Comments

Do you want to know how to get the most bang for your buck? A pulsed laser is your solution.  First, what is a pulsed laser? Unlike a continuous wave (CW) laser which is on continuously during the cutting process, a pulsed laser turns on and off at a rapid pace. During these short pulses Continue reading →

Industrial Laser Cutting: 3 Methods to Guarantee Minimal Scrap and Cut Time

November 8, 2015August 22, 2016Vytek195 22 Comments

Would you rather save on the amount of scrap or the amount of time spent cutting? It’s a difficult trade-off. What would you say if you could do both?

Here are three methods that will minimize scrap and cut time on your next industrial cutting project: Continue reading →

Complex Kiss Cutting: 4 Setup Tips to Ensure Consistent Results

November 3, 2015August 22, 2016Vytek195 12 Comments

Ever have one of those moments when you’re in the middle of a project and you realize something’s off? Maybe your kiss cuts were slightly off line or one sheet happened to turn out just a little bit better than another. Continue reading →

Recent Posts

  • Variables when Laser Cutting PETG
  • Cutting aluminum, brass or copper? It’s all about peak power enabled by a pulsed laser.
  • Marking Automotive Components: A Foolproof Guide to Selecting Marking Method
  • Industrial Laser Cutting: 3 Methods to Guarantee Minimal Scrap and Cut Time
  • Complex Kiss Cutting: 4 Setup Tips to Ensure Consistent Results

Recent Comments

  • Nathan Carter on Cutting aluminum, brass or copper? It’s all about peak power enabled by a pulsed laser.
  • Tyler Johnson on Cutting aluminum, brass or copper? It’s all about peak power enabled by a pulsed laser.
  • Gary on Variables when Laser Cutting PETG
  • laserwoodendiemaker on Industrial Laser Cutting: 3 Methods to Guarantee Minimal Scrap and Cut Time
  • Ville A on Industrial Laser Cutting: 3 Methods to Guarantee Minimal Scrap and Cut Time

Archives

  • September 2016
  • August 2016
  • April 2016
  • November 2015

Categories

  • laser
  • Laser Cutting
  • Laser Marking

Meta

  • Register
  • Log in
  • Entries RSS
  • Comments RSS
  • WordPress.org
Proudly powered by WordPress | Theme: Motif by WordPress.com.